The hanger module seems to work for typical hangers. Once I get to the I-Joist section, it reports zero percent adequacy as if there is no load applied.
Thanks for your message @MaxStability, Unfortunately I was not able to replicate your issue. Could you send me the URL of you sheet here and I can investigate further. Note that only ClearCalcs support can access your calculations through this link, not other users.
Thank you!
Hi Tara,
I’m running into another similar problem where ClearCalcs is reporting the member to not be compatible with the hanger type. See screenshot:
As you can see next to the linked member, FB1 is a global LVL shape. LVL is not listed in the types that are compatible, even though and LVL is a type of SCL (Structural Composite Lumber).